11.3.3.3 Packet Tracer – Using Show Commands

11.3.3.3 Packet Tracer – Using Show Commands

This lab is about 11.3.3.3 Packet Tracer – Using Show Commands . In this tutorial we will discuss about 11.3.3.3 Packet Tracer – Using Show Commands. You may also see the 11.3.2.3 Packet Tracer – Test Connectivity with Traceroute 



11.3.3.3 Packet Tracer – Using Show Commands



Packet Tracer – Using Show Commands

Objectives

Part 1: Analyze Show Command Output




Part 2: Reflection Questions

Background

This activity is designed to reinforce the use of router show commands. You are not required to configure, but rather examine the output of several show commands.

Part 1: Analyze Show Command Output

Step 1: Connect to ISPRouter

a. Click ISP PC, then the Desktop tab, followed by Terminal.

b. Enter privileged EXEC mode.

c. Use the following show commands to answer the Reflection Questions in Part 2:



show arp
show flash:
show ip route
show interfaces
show ip interface brief
show protocols
show users
show version

Part 2: Reflection Questions

1. Which commands would provide the IP address, network prefix, and interface? show ip route, show protocols
(before IOS 15, the show ip route command did not display the IP address of the interfaces)

2. Which commands provide the IP address and interface assignment, but not the network prefix? show ip interface brief

3. Which commands provide the status of the interfaces? show interfaces, show ip interface brief

4. Which commands provide information about the IOS loaded on the router? show version

5. Which commands provide information about the addresses of the router interfaces? show arp, show interfaces

6. Which commands provide information about the amount of and Flash memory available? show version, show flash

7. Which commands provide information about the lines being used for configuration or device monitoring? show users

8. Which commands provide traffic statistics of router interfaces? show interfaces

9. Which commands provide information about paths available for network traffic? show ip route

10. Which interfaces are currently active on the router? GigabitEthernet 0/0, Serial 0/0/1

Ali Hassan

Smart, Motivated, Tech_Geek, Versatile, Adrenaline_junkie, Hard_Working 🙂

One thought to “11.3.3.3 Packet Tracer – Using Show Commands”

Leave a comment

Your email address will not be published. Required fields are marked *